|

Fig 1
The
ARTU® Multi-Purpose Nibbler
attachment is powered by any
drill with a speed range of 1500
to 3000 rpm. The cutting head
can be turned 360° to allow
cutting in a forward, backward,
or sideways motion. A punch moves
up and down inside the die to
make a 4 mm or 5/32” wide
cut. Cutting waste is disposed
through an opening on the
die. Refer to Fig. 1.
The
punch must be used in all four
cutting positions of the die
to get full use. Each punch can
cut approximately 600 to 800
feet depending on the material.
Turning the die 90° provides
a fresh cutting surface on the
punch.

Fig 2
|

Fig 3
The
Nibbler and drill can be hand
held (Fig. 3) or bench
mounted (Fig.
4) to cut desired material.
For best results, use two of
ARTU®'s
Multi-Purpose
Drill Holders (#01560)
for bench mount applications
(Fig. 5).

Fig 4

Fig 5
|